Common Faults And Elimination Methods Of Soft Capsule Production Line In The production

The soft capsule production line is designed for laboratory pharmaceutical research and development, cosmetics, health care products, and military supplies. The model and output match the specifications. Considering the elastic characteristics of output, the equipment can be upgraded and transformed to speed up the output without the need to purchase new equipment. Therefore, the equipment has a wide range of compatibility, and one set of equipment can adapt to multiple production levels, so from the perspective of safety, the economic advantages of our company's products are considerable.

Common faults and troubleshooting methods of soft capsule production line in the production process:

1. The rubber skin is split or grooves appear. ——Cause: There may be dry glue or mechanical debris on the baffle at the glue outlet of the gelatin box. );

2. The rubber skin is uneven or shows wavy lines with hard glue---reason: the rubber skin is oily-the bottom of the rubber skin can be wiped clean with a cloth;

3. The rubber sticks to the rubber wheel——the amount of cold air is too small, the air temperature or the temperature of Mingjiao is too high——the amount of cold air can be increased, and the temperature of Mingjiao can be reduced;

4. The width of the rubber is not enough - there are obstacles at the outlet of the gelatin box, and the amount of cold air is too large - clear the obstacles and reduce the amount of cold air;

5. Capsule seam cracking——the rubber skin is too thick, the gelatin random cloth is qualified, the rolling die is wrong, the temperature of the spray body is too low, and the material liquid cloth is adapted——the thickness of the rubber skin can be reduced, the gelatin can be replaced, and the line can be re-aligned , Increase the temperature of the spray body, check the material liquid;

Capsule filling quantity distribution --- air in the material liquid, material liquid is too thick to stick or precipitate at the end of the piston rod, seal leakage of the feed pump plunger feed pipe or mechanical debris in the spray body--- can be excluded Air in the liquid, increase the stroke of the feeding pump for a few minutes, re-batch, replace the seal, etc.;

In addition, the disintegration delay problem of soft capsules may not only be affected by a, capsule shell (material, composition ratio, thickness, water content) b contents c external environment (storage conditions), but also related to production process conditions such as soft capsules Too long drying time, too high drying temperature and too high humidity will accelerate its aging and affect disintegration.